aboutsummaryrefslogtreecommitdiffstats
path: root/src
Commit message (Expand)AuthorAgeFilesLines
* Rename everything significant to Kutter except for docsTomasz Kramkowski2025-08-1520-74/+74
* avr: Switch to input state prior to enabling pullup in gpio_in_reset()Kevin O'Connor2025-07-221-4/+8
* i2c_software: Place wires in high impedance state after setupKevin O'Connor2025-07-221-2/+2
* i2c_software: Implement regular timing even on AVR chipsKevin O'Connor2025-07-221-9/+0
* stm32: make i2c distinguish I2C NACKsTimofey Titovets2025-07-171-22/+38
* sos_filter: fix overflows_int32 (#6976)Findlay Feng2025-07-111-1/+1
* stm32: f0 do not send empty write on readTimofey Titovets2025-07-091-9/+11
* stm32: f0 make i2c distinguish I2C NACKsTimofey Titovets2025-07-091-1/+11
* load_cell_probe: Fix warnings on avr buildsKevin O'Connor2025-06-181-2/+2
* stm32: Adding more hardware pwm capable pins for STM32Hx series chips (#6965)jimmyjon7112025-06-181-0/+22
* sos_filter: Fix validate_section_index() checkKevin O'Connor2025-06-111-2/+3
* ar100: Convert to or1k-elf toolchainKevin O'Connor2025-06-081-1/+1
* rp2040: Prefer larger postdiv1 on rp2040 chipsKevin O'Connor2025-06-021-2/+2
* stm32: Add comments on PLL frequency requirements to clock setup codeKevin O'Connor2025-06-029-0/+22
* stm32: Run stm32g431 at 170MhzKevin O'Connor2025-05-313-5/+8
* stm32: Fix spi overflow issue on stm32h7Kevin O'Connor2025-05-301-8/+6
* rp2040: Fix spi overflow issueKevin O'Connor2025-05-301-4/+9
* rp2040: spi - enable fifoTimofey Titovets2025-05-301-4/+8
* stm32: Support using CANBUS on PB5/PB6 on stm32h7 chipsKevin O'Connor2025-05-302-2/+6
* stm32: Simplify Kconfig HAVE_STM32_CANBUS checksKevin O'Connor2025-05-301-7/+7
* sos_filter: Improve error checking on section_idxKevin O'Connor2025-05-291-5/+13
* sensor_hx71x: Update Sensors to report to load_cell_probeGareth Farrington2025-05-292-0/+32
* load_cell_probe: Create load_cell_probe MCU objectGareth Farrington2025-05-294-1/+314
* sos_filter: Second Order Sections MCU FilterGareth Farrington2025-05-294-0/+175
* stm32: h7 spi - add a delay on SCK polarity changeTimofey Titovets2025-05-261-2/+9
* spi_software: add a delay on mode changeTimofey Titovets2025-05-261-5/+8
* rp2040: add a delay on SCK polarity changeTimofey Titovets2025-05-261-0/+7
* stm32: Allow stm32g4 chips to select a bootloaderKevin O'Connor2025-05-191-1/+1
* stm32: spi enable fifo if supported (#6936)Timofey Titovets2025-05-191-7/+21
* stm32: H7 spi enable use of fifoTimofey Titovets2025-05-191-4/+8
* stm32: Avoid read-modify-write register access in stm32h7_spi.cKevin O'Connor2025-05-161-20/+16
* stepper: Minor code tweak - remove unneeded parenthesisKevin O'Connor2025-05-091-1/+1
* stepper: Minor code reorg - remove unneeded HAVE_OPTIMIZED_PATH definitionKevin O'Connor2025-05-091-8/+7
* stepper: Also ensure minimum time after dir change and next stepKevin O'Connor2025-05-091-3/+11
* stepper: Ensure minimum time between step pin and dir pin changeKevin O'Connor2025-05-091-0/+4
* stepper: Move timer checks from stepper_event_full() to stepper_load_next()Kevin O'Connor2025-05-091-10/+16
* stepper: Free stepper_move struct near top of stepper_load_next()Kevin O'Connor2025-05-091-18/+26
* stm32: Run stm32h723 at 520MhzKevin O'Connor2025-05-022-2/+4
* stm32: Support over 400Mhz main clock in stm32h7_adc.cKevin O'Connor2025-05-021-6/+7
* stm32: Use 12Mhz nominal internal clock in stm32f0_i2c.cKevin O'Connor2025-05-021-9/+9
* neopixel: Round up in nsecs_to_ticks()Kevin O'Connor2025-04-281-1/+1
* stm32: Enable VOS0 power mode on stm32h723 if frequency above 400MhzKevin O'Connor2025-04-281-11/+15
* stm32: Don't try to set incorrect PWR->CR3 register on stm32h7Kevin O'Connor2025-04-281-5/+3
* stm32: Set the PLL frequency equal to CONFIG_CLOCK_FREQ on stm32h723Kevin O'Connor2025-04-281-1/+1
* stm32: Avoid read-modify-write register updates in stm32h7 clock_setup()Kevin O'Connor2025-04-281-58/+39
* stm32: Use enable_pclock() in stm32h7 clock_setup()Kevin O'Connor2025-04-281-5/+4
* stm32h7: Always clear AHB1ENR at startup on stm32h7Kevin O'Connor2025-04-281-5/+1
* basecmd: Update stats timing check to support 32bit durationKevin O'Connor2025-04-281-1/+8
* stm32: Add support for spi6 on stm32f42x chipsRussell Cloran2025-04-191-0/+7
* stm32: Fix pll_base on stm32h7 when using a clock other than 25MhzKevin O'Connor2025-04-191-1/+1
generated by cgit v1.2.3-70-g09d2 (git 2.50.1) at 2025-09-01 14:42:34 +0000