aboutsummaryrefslogtreecommitdiffstats
path: root/klippy/extras/servo.py
Commit message (Expand)AuthorAgeFilesLines
* Run black on all first party python codeTomasz Kramkowski2025-08-061-26/+44
* output_pin: Improve GCodeRequestQueue timing on duplicate requestsKevin O'Connor2024-09-161-4/+4
* servo: Use GCodeRequestQueue to queue updatesKevin O'Connor2024-09-121-12/+11
* servo: Asynchronous adjustments of servo positionDmitry Butyugin2024-08-031-3/+5
* servo: Set initial value via mcu_servo.setup_start_value()Kevin O'Connor2020-07-251-30/+21
* servo: Remove servo ENABLE parameterKevin O'Connor2020-07-251-16/+6
* servo: Use new GCodeCommand wrappersKevin O'Connor2020-05-051-16/+15
* servo: add get_status methodJanar Sööt2019-06-041-0/+2
* klippy: Convert printer_state("ready") to an event handlerKevin O'Connor2019-01-081-6/+6
* servo: This patch create ability to enable/disable attached servo. (#880)Jiri Dobry2018-11-141-4/+16
* servo: Wrap lines to 80 columnsKevin O'Connor2018-10-101-10/+15
* servo: Adding support for startup value for servos (#676)Chris Whiteford2018-10-051-9/+25
* servo: Use new gcode.register_mux_command()Kevin O'Connor2018-05-201-8/+4
* pins: Remove module level get_printer_pins() and setup_pin() functionsKevin O'Connor2018-04-041-2/+2
* klippy: Introduce load_config_prefix() for modules that take parametersKevin O'Connor2018-02-031-1/+1
* servo: Move the servo code from chipmisc.py to extras directoryKevin O'Connor2018-01-281-0/+59
generated by cgit v1.2.3-70-g09d2 (git 2.50.1) at 2025-09-01 22:11:09 +0000