diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 16 |
1 files changed, 11 insertions, 5 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 37e363f4..34250df6 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -206,6 +206,10 @@ The following standard commands are supported: for calibrating a Z position_endstop config setting. See the MANUAL_PROBE command for details on the parameters and the additional commands available while the tool is active. + `Z_ENDSTOP_UPDATE_POSITION`: Take the current Z Gcode offset (aka, + babystepping), and subtract it from the stepper_z endstop_position. + This acts to take a frequently used babystepping value, and "make + it permanent". Requires a `SAVE_CONFIG` to take effect. - `TUNING_TOWER COMMAND=<command> PARAMETER=<name> START=<value> FACTOR=<value> [BAND=<value>]`: A tool for tuning a parameter on each Z height during a print. The tool will run the given COMMAND @@ -351,11 +355,13 @@ the [probe calibrate guide](Probe_Calibrate.md)): section. - `PROBE_CALIBRATE [SPEED=<speed>] [<probe_parameter>=<value>]`: Run a helper script useful for calibrating the probe's z_offset. See the - PROBE command for details on the optional probe parameters. See the - MANUAL_PROBE command for details on the SPEED parameter and the - additional commands available while the tool is active. Please note, - the PROBE_CALIBRATE command uses the speed variable to move in XY direction - as well as Z. + PROBE command for details on the optional probe parameters. See + the MANUAL_PROBE command for details on the SPEED parameter and the additional commands available while the tool is active. Please note, the PROBE_CALIBRATE command uses the speed variable + to move in XY direction as well as Z. +`PROBE_UPDATE_OFFSET`: Take the current Z Gcode offset (aka, + babystepping), and subtract if from the probe's z_offset. + This acts to take a frequently used babystepping value, and "make + it permanent". Requires a `SAVE_CONFIG` to take effect. ## BLTouch |