diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 3 |
1 files changed, 3 insertions, 0 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 029c9ae0..a7d1adcd 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -153,6 +153,9 @@ The following standard commands are supported: - `SET_HEATER_TEMPERATURE HEATER=<heater_name> [TARGET=<target_temperature>]`: Sets the target temperature for a heater. If a target temperature is not supplied, the target is 0. +- `ACTIVATE_EXTRUDER EXTRUDER=<config_name>`: In a printer with + multiple extruders this command is used to change the active + extruder. - `SET_PRESSURE_ADVANCE [EXTRUDER=<config_name>] [ADVANCE=<pressure_advance>] [SMOOTH_TIME=<pressure_advance_smooth_time>]`: Set pressure advance parameters. If EXTRUDER is not specified, it defaults to the active |