diff options
Diffstat (limited to 'config/printer-creality-ender6-2020.cfg')
| -rw-r--r-- | config/printer-creality-ender6-2020.cfg | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/config/printer-creality-ender6-2020.cfg b/config/printer-creality-ender6-2020.cfg index 00875018..a5791a84 100644 --- a/config/printer-creality-ender6-2020.cfg +++ b/config/printer-creality-ender6-2020.cfg @@ -1,7 +1,7 @@ # This file contains pin mappings for the stock 2020 Creality Ender 6. -# To use this config, during "make menuconfig" select the -# STM32F103 with a "28KiB bootloader" and with "Use USB for -# communication" disabled. +# To use this config, during "make menuconfig" select the STM32F103 +# with a "28KiB bootloader" and serial (on USART1 PA10/PA9) +# communication. # Because this printer has factory wiring, mounts, and firmware for # a BLTouch, but does not ship with one at this time, default values @@ -10,9 +10,9 @@ # customize the offsets, particularly z-offset, for their specific unit. # If you prefer a direct serial connection, in "make menuconfig" -# select "Enable extra low-level configuration options" and select the -# USART3 serial port, which is broken out on the 10 pin IDC cable used -# for the LCD module as follows: +# select "Enable extra low-level configuration options" and select +# serial (on USART3 PB11/PB10), which is broken out on the 10 pin IDC +# cable used for the LCD module as follows: # 3: Tx, 4: Rx, 9: GND, 10: VCC # Flash this firmware by copying "out/klipper.bin" to a SD card and |