diff options
Diffstat (limited to 'config/example.cfg')
| -rw-r--r-- | config/example.cfg | 38 |
1 files changed, 2 insertions, 36 deletions
diff --git a/config/example.cfg b/config/example.cfg index 4bb805db..32ece835 100644 --- a/config/example.cfg +++ b/config/example.cfg @@ -2,7 +2,8 @@ # copy and edit this file to configure a new cartesian style # printer. For delta style printers, see the "example-delta.cfg" # file. For corexy/h-bot style printers, see the "example-corexy.cfg" -# file. +# file. Only common config sections are described here - see the +# "example-extras.cfg" file for configuring less common devices. # DO NOT COPY THIS FILE WITHOUT CAREFULLY READING AND UPDATING IT # FIRST. Incorrectly configured parameters may cause damage. @@ -150,18 +151,6 @@ filament_diameter: 3.500 # otherwise cause retraction followed immediately by pressure # buildup. This setting only applies if pressure_advance is # non-zero. The default is 0.010 (10 milliseconds). -#deactivate_gcode: -# A list of G-Code commands (one per line) to execute on a G-Code -# tool change command (eg, "T1") that deactivates this extruder and -# activates some other extruder. It only makes sense to define this -# section on multi-extruder printers. The default is to not run any -# special G-Code commands on deactivation. -#activate_gcode: -# A list of G-Code commands (one per line) to execute on a G-Code -# tool change command (eg, "T0") that activates this extruder. It -# only makes sense to define this section on multi-extruder -# printers. The default is to not run any special G-Code commands on -# activation. # # The remaining variables describe the extruder heater. heater_pin: ar10 @@ -217,15 +206,6 @@ max_temp: 210 # Maximum temperature (mcu will shutdown if temperature is above # this value). This parameter must be provided. -# In a multi-extruder printer add an additional extruder section for -# each additional extruder. The additional extruder sections should be -# named "extruder1", "extruder2", "extruder3", and so on. See the -# "extruder" section above for a description of available parameters. -#[extruder1] -#step_pin: ar36 -#dir_pin: ar34 -#... - # The heater_bed section describes a heated bed (if present - omit # section if not present). [heater_bed] @@ -323,17 +303,3 @@ max_z_accel: 30 # centripetal velocity cornering algorithm. A larger number will # permit higher "cornering speeds" at the junction of two moves. The # default is 0.02mm. - -# Heater cooling fans (one may define any number of sections with a -# "heater_fan" prefix). A "heater fan" is a fan that will be enabled -# whenever its associated heater is active. -#[heater_fan my_nozzle_fan] -# See the "fan" section for fan configuration parameters. -#pin: ar4 -# The remaining variables are specific to heater_fan. -#heater: extruder -# Name of the config section defining the heater that this fan is -# associated with. The default is "extruder". -#heater_temp: 50.0 -# A temperature (in Celsius) that the heater must drop below before -# the fan is disabled. The default is 50 Celsius. |