diff options
| author | Kevin O'Connor <kevin@koconnor.net> | 2018-07-08 10:12:23 -0400 |
|---|---|---|
| committer | Kevin O'Connor <kevin@koconnor.net> | 2018-07-08 10:12:23 -0400 |
| commit | b4f03e8363b66cea84e1b84d58f05a6365b0ff0e (patch) | |
| tree | e98784393143468c9104d7ffcc844f648c43af13 /docs/G-Codes.md | |
| parent | 649d7c54f0ec0bab03c372ced7fc331d8bc8919a (diff) | |
| download | kutter-b4f03e8363b66cea84e1b84d58f05a6365b0ff0e.tar.gz kutter-b4f03e8363b66cea84e1b84d58f05a6365b0ff0e.tar.xz kutter-b4f03e8363b66cea84e1b84d58f05a6365b0ff0e.zip | |
docs: Add display g-code commands to docs/G-Codes.md
Add M117 and M73 to the list of supported G-Codes.
Also, remove M117 from the list of commands reported by the HELP
command as that command is typically only used to list "extended
g-code" commands.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 7 |
1 files changed, 7 insertions, 0 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 0a5fa7e0..b921e3ce 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -48,6 +48,13 @@ Klipper also supports the following standard G-Code commands if the - Set SD position: `M26 S<offset>` - Report SD print status: `M27` +## G-Code display commands + +The following standard G-Code commands are available if a "display" +config section is enabled: +- Display Message: `M117 <message>` +- Set build percentage: `M73 P<percent>` + # Extended G-Code Commands Klipper uses "extended" G-Code commands for general configuration and |