From b4f03e8363b66cea84e1b84d58f05a6365b0ff0e Mon Sep 17 00:00:00 2001 From: Kevin O'Connor Date: Sun, 8 Jul 2018 10:12:23 -0400 Subject: docs: Add display g-code commands to docs/G-Codes.md Add M117 and M73 to the list of supported G-Codes. Also, remove M117 from the list of commands reported by the HELP command as that command is typically only used to list "extended g-code" commands. Signed-off-by: Kevin O'Connor --- docs/G-Codes.md | 7 +++++++ 1 file changed, 7 insertions(+) (limited to 'docs/G-Codes.md') diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 0a5fa7e0..b921e3ce 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -48,6 +48,13 @@ Klipper also supports the following standard G-Code commands if the - Set SD position: `M26 S` - Report SD print status: `M27` +## G-Code display commands + +The following standard G-Code commands are available if a "display" +config section is enabled: +- Display Message: `M117 ` +- Set build percentage: `M73 P` + # Extended G-Code Commands Klipper uses "extended" G-Code commands for general configuration and -- cgit v1.2.3-70-g09d2