blob: 070d4495bff7de2eb27d58f17182510318f73d95 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
|
# Main Kconfig settings
mainmenu "Klipper Firmware Configuration"
choice
prompt "Micro-controller Architecture"
config MACH_AVR
bool "Atmega AVR"
config MACH_SAM3X8E
bool "SAM3x8e (Arduino Due)"
config MACH_SIMU
bool "Host simulator"
endchoice
source "src/avr/Kconfig"
source "src/sam3x8e/Kconfig"
source "src/simulator/Kconfig"
# The HAVE_GPIO_x options allow boards to disable support for some
# commands if the hardware does not support the feature.
config HAVE_GPIO_ADC
bool
default n
config HAVE_GPIO_SPI
bool
default n
config HAVE_GPIO_HARD_PWM
bool
default n
config NO_UNSTEP_DELAY
# Slow micro-controllers do not require a delay before returning a
# stepper step pin to its default level. A board can enable this
# option to optimize the stepper_event() handler in this case.
bool
default n
config INLINE_STEPPER_HACK
# Enables gcc to inline stepper_event() into the main timer irq handler
bool
default y
|
