blob: e94ff5b2f445775d8e828cd16b150d526ef9636c (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
|
# Main Kconfig settings
mainmenu "Klipper Firmware Configuration"
choice
prompt "Micro-controller Architecture"
config MACH_AVR
bool "Atmega AVR"
config MACH_SAM3
bool "SAM3/SAM4 (Due and Duet)"
config MACH_SAMD21
bool "SAMD21 (Arduino Zero)"
config MACH_LPC176X
bool "LPC176x (Smoothieboard)"
config MACH_STM32F1
bool "STMicroelectronics STM32F103"
config MACH_PRU
bool "Beaglebone PRU"
config MACH_LINUX
bool "Linux process"
config MACH_SIMU
bool "Host simulator"
endchoice
source "src/avr/Kconfig"
source "src/sam3/Kconfig"
source "src/samd21/Kconfig"
source "src/lpc176x/Kconfig"
source "src/stm32f1/Kconfig"
source "src/pru/Kconfig"
source "src/linux/Kconfig"
source "src/simulator/Kconfig"
# The HAVE_GPIO_x options allow boards to disable support for some
# commands if the hardware does not support the feature.
config HAVE_GPIO
bool
default n
config HAVE_GPIO_ADC
bool
default n
config HAVE_GPIO_SPI
bool
default n
config HAVE_GPIO_I2C
bool
default n
config HAVE_GPIO_HARD_PWM
bool
default n
config HAVE_GPIO_BITBANGING
bool
default n
config NO_UNSTEP_DELAY
# Slow micro-controllers do not require a delay before returning a
# stepper step pin to its default level. A board can enable this
# option to optimize the stepper_event() handler in this case.
bool
default n
config INLINE_STEPPER_HACK
# Enables gcc to inline stepper_event() into the main timer irq handler
bool
depends on HAVE_GPIO
default y
|
