diff options
Diffstat (limited to 'docs')
| -rw-r--r-- | docs/BLTouch.md | 24 | ||||
| -rw-r--r-- | docs/FAQ.md | 7 |
2 files changed, 14 insertions, 17 deletions
diff --git a/docs/BLTouch.md b/docs/BLTouch.md index c99f6035..199ca153 100644 --- a/docs/BLTouch.md +++ b/docs/BLTouch.md @@ -20,24 +20,20 @@ control_pin: P1.26 If the BL-Touch will be used to home the Z axis then set `endstop_pin: probe:z_virtual_endstop` in the `[stepper_z]` config section and add a -`[homing_override]` config section to raise the z-axis, home the -x/y-axis, move to the center of the bed, and home the z-axis. For -example: +`[safe_z_home]` config section to raise the z axis, home the xy axes, +move to the center of the bed, and home the z axis. For example: ``` -[homing_override] -gcode: - G90 ; Use absolute position mode - G1 Z10 ; Move up 10mm - G28 X Y - G1 X166 Y120 F6000 ; Change the X and Y coordinates to the center of your print bed - G28 Z -set_position_z: 0.0 +[safe_z_home] +home_xy_position: 100,100 # Change coordinates to the center of your print bed +speed: 50 +z_hop: 10 # Move up 10mm +z_hop_speed: 5 ``` -It's important that the initial Z upwards movement in the -homing_override is high enough that the probe doesn't hit anything -even if the probe pin happens to be in its lowest state. +It's important that the z_hop movement in safe_z_home is high enough +that the probe doesn't hit anything even if the probe pin happens to +be in its lowest state. Initial tests ============= diff --git a/docs/FAQ.md b/docs/FAQ.md index 56490520..e3e3b163 100644 --- a/docs/FAQ.md +++ b/docs/FAQ.md @@ -211,9 +211,10 @@ the desired movement to the "custom g-code" section of your slicer. If the printer requires some additional movement as part of the homing process itself (or fundamentally does not have a homing process) then -consider using a homing_override section in the config file. If you -need to move a stepper for diagnostic or debugging purposes then -consider adding a force_move section to the config file. See +consider using a safe_z_home or homing_override section in the config +file. If you need to move a stepper for diagnostic or debugging +purposes then consider adding a force_move section to the config +file. See [example-extras.cfg](https://github.com/KevinOConnor/klipper/tree/master/config/example-extras.cfg) for further details on these options. |