diff options
Diffstat (limited to 'docs/Resonance_Compensation.md')
| -rw-r--r-- | docs/Resonance_Compensation.md | 10 |
1 files changed, 5 insertions, 5 deletions
diff --git a/docs/Resonance_Compensation.md b/docs/Resonance_Compensation.md index aaeaf7ab..31f1b35e 100644 --- a/docs/Resonance_Compensation.md +++ b/docs/Resonance_Compensation.md @@ -48,8 +48,8 @@ First, measure the **ringing frequency**. to 5.0. It is not advised to increase it when using input shaper because it can cause more smoothing in parts - it is better to use higher acceleration value instead. -2. Increase `max_accel_to_decel` by issuing the following command: - `SET_VELOCITY_LIMIT ACCEL_TO_DECEL=7000` +2. Disable the `miminum_cruise_ratio` feature by issuing the following + command: `SET_VELOCITY_LIMIT MINIMUM_CRUISE_RATIO=0` 3. Disable Pressure Advance: `SET_PRESSURE_ADVANCE ADVANCE=0` 4. If you have already added `[input_shaper]` section to the printer.cfg, execute `SET_INPUT_SHAPER SHAPER_FREQ_X=0 SHAPER_FREQ_Y=0` command. If you @@ -149,7 +149,7 @@ a few other related parameters. Print the ringing test model as follows: 1. Restart the firmware: `RESTART` -2. Prepare for test: `SET_VELOCITY_LIMIT ACCEL_TO_DECEL=7000` +2. Prepare for test: `SET_VELOCITY_LIMIT MINIMUM_CRUISE_RATIO=0` 3. Disable Pressure Advance: `SET_PRESSURE_ADVANCE ADVANCE=0` 4. Execute: `SET_INPUT_SHAPER SHAPER_TYPE=MZV` 5. Execute the command: @@ -270,7 +270,7 @@ frequencies after enabling [input_shaper], this section will not help with that. Assuming that you have sliced the ringing model with suggested parameters, complete the following steps for each of the axes X and Y: -1. Prepare for test: `SET_VELOCITY_LIMIT ACCEL_TO_DECEL=7000` +1. Prepare for test: `SET_VELOCITY_LIMIT MINIMUM_CRUISE_RATIO=0` 2. Make sure Pressure Advance is disabled: `SET_PRESSURE_ADVANCE ADVANCE=0` 3. Execute: `SET_INPUT_SHAPER SHAPER_TYPE=ZV` 4. From the existing ringing test model with your chosen input shaper select @@ -331,7 +331,7 @@ with suggested parameters, print the test model 3 times as follows. First time, prior to printing, run 1. `RESTART` -2. `SET_VELOCITY_LIMIT ACCEL_TO_DECEL=7000` +2. `SET_VELOCITY_LIMIT MINIMUM_CRUISE_RATIO=0` 3. `SET_PRESSURE_ADVANCE ADVANCE=0` 4. `SET_INPUT_SHAPER SHAPER_TYPE=2HUMP_EI SHAPER_FREQ_X=60 SHAPER_FREQ_Y=60` 5. `TUNING_TOWER COMMAND=SET_VELOCITY_LIMIT PARAMETER=ACCEL START=1500 STEP_DELTA=500 STEP_HEIGHT=5` |