diff options
Diffstat (limited to 'docs/Manual_Level.md')
| -rw-r--r-- | docs/Manual_Level.md | 30 |
1 files changed, 15 insertions, 15 deletions
diff --git a/docs/Manual_Level.md b/docs/Manual_Level.md index 6a49d499..2b73e8b4 100644 --- a/docs/Manual_Level.md +++ b/docs/Manual_Level.md @@ -63,9 +63,9 @@ This is done by creating a `[bed_screws]` config section. For example, it might look something similar to: ``` [bed_screws] -screw1: 100,50 -screw2: 100,150 -screw3: 150,100 +screw1: 100, 50 +screw2: 100, 150 +screw3: 150, 100 ``` If a bed screw is under the bed, then specify the XY position directly @@ -79,8 +79,8 @@ then one can start the tool by running: BED_SCREWS_ADJUST ``` -This tool will move the printer's nozzle to each screw XY location and -then move the nozzle to a Z=0 height. At this point one can use the +This tool will move the printer's nozzle to each screw XY location +and then move the nozzle to a Z=0 height. At this point one can use the "paper test" to adjust the bed screw directly under the nozzle. See the information described in ["the paper test"](Bed_Level.md#the-paper-test), but adjust the bed @@ -126,12 +126,12 @@ coordinates and add them to the config file. For example, it might look like: ``` [bed_screws] -screw1: 100,50 -screw1_fine_adjust: 0,0 -screw2: 100,150 -screw2_fine_adjust: 300,300 -screw3: 150,100 -screw3_fine_adjust: 0,100 +screw1: 100, 50 +screw1_fine_adjust: 0, 0 +screw2: 100, 150 +screw2_fine_adjust: 300, 300 +screw3: 150, 100 +screw3_fine_adjust: 0, 100 ``` When this feature is enabled, the `BED_SCREWS_ADJUST` tool will first @@ -151,13 +151,13 @@ config file. For example, it might look like: ``` [screws_tilt_adjust] -screw1: -5,30 +screw1: -5, 30 screw1_name: front left screw -screw2: 155,30 +screw2: 155, 30 screw2_name: front right screw -screw3: 155,190 +screw3: 155, 190 screw3_name: rear right screw -screw4: -5,190 +screw4: -5, 190 screw4_name: rear left screw horizontal_move_z: 10. speed: 50. |