diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 3 |
1 files changed, 3 insertions, 0 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 009debc1..65f01f9d 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -88,6 +88,9 @@ The following standard commands are supported: [ADVANCE_LOOKAHEAD_TIME=<pressure_advance_lookahead_time>]`: Set pressure advance parameters. If EXTRUDER is not specified, it defaults to the active extruder. +- `STEPPER_BUZZ STEPPER=<config_name>`: Move the given stepper forward + one mm and then backward one mm, repeated 10 times. This is a + diagnostic tool to help verify stepper connectivity. - `RESTART`: This will cause the host software to reload its config and perform an internal reset. This command will not clear error state from the micro-controller (see FIRMWARE_RESTART) nor will it |