diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 7 |
1 files changed, 7 insertions, 0 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 0a5fa7e0..b921e3ce 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -48,6 +48,13 @@ Klipper also supports the following standard G-Code commands if the - Set SD position: `M26 S<offset>` - Report SD print status: `M27` +## G-Code display commands + +The following standard G-Code commands are available if a "display" +config section is enabled: +- Display Message: `M117 <message>` +- Set build percentage: `M73 P<percent>` + # Extended G-Code Commands Klipper uses "extended" G-Code commands for general configuration and |