diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 4 |
1 files changed, 2 insertions, 2 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 9c62acff..01e16570 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -663,7 +663,7 @@ retraction required. The following commands are available when the [skew_correction config section](Config_Reference.md#skew_correction) -is enabled (also see the [skew correction guide](skew_correction.md)): +is enabled (also see the [Skew Correction](Skew_Correction.md) guide): - `SET_SKEW [XY=<ac_length,bd_length,ad_length>] [XZ=<ac,bd,ad>] [YZ=<ac,bd,ad>] [CLEAR=<0|1>]`: Configures the [skew_correction] module with measurements (in mm) taken from a calibration print. @@ -678,7 +678,7 @@ is enabled (also see the [skew correction guide](skew_correction.md)): degrees) based on a measured print. This can be useful for determining the printer's current skew after correction has been applied. It may also be useful before correction is applied to - determine if skew correction is necessary. See skew_correction.md + determine if skew correction is necessary. See [Skew Correction](Skew_Correction.md) for details on skew calibration objects and measurements. - `SKEW_PROFILE [LOAD=<name>] [SAVE=<name>] [REMOVE=<name>]`: Profile management for skew_correction. LOAD will restore skew state from |