diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 34 |
1 files changed, 17 insertions, 17 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 2adcb0d9..dbfd0b85 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -690,29 +690,29 @@ scheduled to run after the stepper move completes, however if a manual stepper move uses SYNC=0 then future G-Code movement commands may run in parallel with the stepper movement. -### [neopixel] +### [led] -The following command is available when a -[neopixel config section](Config_Reference.md#neopixel) or -[dotstar config section](Config_Reference.md#dotstar) is enabled. +The following command is available when any of the +[led config sections](Config_Reference.md#leds) are enabled. #### SET_LED `SET_LED LED=<config_name> RED=<value> GREEN=<value> BLUE=<value> WHITE=<value> [INDEX=<index>] [TRANSMIT=0] [SYNC=1]`: This sets the LED output. Each color `<value>` must be between 0.0 and 1.0. The -WHITE option is only valid on RGBW LEDs. If multiple LED chips are -daisy-chained then one may specify INDEX to alter the color of just -the given chip (1 for the first chip, 2 for the second, etc.). If -INDEX is not provided then all LEDs in the daisy-chain will be set to -the provided color. If TRANSMIT=0 is specified then the color change -will only be made on the next SET_LED command that does not specify -TRANSMIT=0; this may be useful in combination with the INDEX parameter -to batch multiple updates in a daisy-chain. By default, the SET_LED -command will sync it's changes with other ongoing gcode commands. -This can lead to undesirable behavior if LEDs are being set while the -printer is not printing as it will reset the idle timeout. If careful -timing is not needed, the optional SYNC=0 parameter can be specified -to apply the changes instantly and not reset the idle timeout. +WHITE option is only valid on RGBW LEDs. If the LED supports multiple +chips in a daisy-chain then one may specify INDEX to alter the color +of just the given chip (1 for the first chip, 2 for the second, +etc.). If INDEX is not provided then all LEDs in the daisy-chain will +be set to the provided color. If TRANSMIT=0 is specified then the +color change will only be made on the next SET_LED command that does +not specify TRANSMIT=0; this may be useful in combination with the +INDEX parameter to batch multiple updates in a daisy-chain. By +default, the SET_LED command will sync it's changes with other ongoing +gcode commands. This can lead to undesirable behavior if LEDs are +being set while the printer is not printing as it will reset the idle +timeout. If careful timing is not needed, the optional SYNC=0 +parameter can be specified to apply the changes without resetting the +idle timeout. ### [output_pin] |