diff options
Diffstat (limited to 'docs/G-Codes.md')
| -rw-r--r-- | docs/G-Codes.md | 22 |
1 files changed, 22 insertions, 0 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index 0b8aa6e5..e55fba35 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -984,6 +984,28 @@ babystepping), and subtract if from the probe's z_offset. This acts to take a frequently used babystepping value, and "make it permanent". Requires a `SAVE_CONFIG` to take effect. +### [probe_eddy_current] + +The following commands are available when a +[probe_eddy_current config section](Config_Reference.md#probe_eddy_current) +is enabled. + +#### PROBE_EDDY_CURRENT_CALIBRATE +`PROBE_EDDY_CURRENT_CALIBRATE CHIP=<config_name>`: This starts a tool +that calibrates the sensor resonance frequencies to corresponding Z +heights. The tool will take a couple of minutes to complete. After +completion, use the SAVE_CONFIG command to store the results in the +printer.cfg file. + +#### LDC_CALIBRATE_DRIVE_CURRENT +`LDC_CALIBRATE_DRIVE_CURRENT CHIP=<config_name>` This tool will +calibrate the ldc1612 DRIVE_CURRENT0 register. Prior to using this +tool, move the sensor so that it is near the center of the bed and +about 20mm above the bed surface. Run this command to determine an +appropriate DRIVE_CURRENT for the sensor. After running this command +use the SAVE_CONFIG command to store that new setting in the +printer.cfg config file. + ### [pwm_cycle_time] The following command is available when a |