diff options
Diffstat (limited to 'docs/FAQ.md')
| -rw-r--r-- | docs/FAQ.md | 29 |
1 files changed, 15 insertions, 14 deletions
diff --git a/docs/FAQ.md b/docs/FAQ.md index abcb501b..d571c1a9 100644 --- a/docs/FAQ.md +++ b/docs/FAQ.md @@ -103,12 +103,12 @@ and make sure FLASH_DEVICE is set correctly for your board (see the However, if "make flash" just doesn't work for your board, then you will need to manually flash. See if there is a config file in the -[config directory](https://github.com/KevinOConnor/klipper/tree/master/config) -with specific instructions for flashing the device. Also, check the -board manufacturer's documentation to see if it describes how to flash -the device. Finally, it may be possible to manually flash the device -using tools such as "avrdude" or "bossac" - see the -[bootloader document](Bootloaders.md) for additional information. +[config directory](../config) with specific instructions for flashing +the device. Also, check the board manufacturer's documentation to see +if it describes how to flash the device. Finally, it may be possible +to manually flash the device using tools such as "avrdude" or +"bossac" - see the [bootloader document](Bootloaders.md) for +additional information. ### How do I change the serial baud rate? @@ -159,8 +159,7 @@ Klipper has been run on other machines. The Klipper host software only requires Python running on a Linux (or similar) computer. However, if you wish to run it on a different machine you will need Linux admin knowledge to install the system prerequisites for that particular -machine. See the -[install-octopi.sh](https://github.com/KevinOConnor/klipper/tree/master/scripts/install-octopi.sh) +machine. See the [install-octopi.sh](../scripts/install-octopi.sh) script for further information on the necessary Linux admin steps. If you are looking to run the Klipper host software on a low-end chip, @@ -199,10 +198,9 @@ own pseudo-tty. For example: If you choose to do this, you will need to implement the necessary start, stop, and installation scripts (if any). The -[install-octopi.sh](https://github.com/KevinOConnor/klipper/tree/master/scripts/install-octopi.sh) -script and the -[klipper-start.sh](https://github.com/KevinOConnor/klipper/tree/master/scripts/klipper-start.sh) -script may be useful as examples. +[install-octopi.sh](../scripts/install-octopi.sh) script and the +[klipper-start.sh](../scripts/klipper-start.sh) script may be useful +as examples. ### Do I have to use OctoPrint? @@ -544,9 +542,12 @@ flash" commands are needed for a software change to take effect. ### How do I uninstall Klipper? -On the firmware end, nothing special needs to happen. Just follow the flashing directions for the new firmware. +On the firmware end, nothing special needs to happen. Just follow the +flashing directions for the new firmware. -On the raspberry pi end, an uninstall script is available in [`scripts/klipper-uninstall.sh`](https://github.com/KevinOConnor/klipper/blob/master/scripts/klipper-uninstall.sh). Assuming you cloned `klipper` to `$HOME` +On the raspberry pi end, an uninstall script is available in +[scripts/klipper-uninstall.sh](../scripts/klipper-uninstall.sh). For +example: ``` sudo ~/klipper/scripts/klipper-uninstall.sh rm -rf ~/klippy-env ~/klipper |