diff options
Diffstat (limited to 'docs/Config_Reference.md')
| -rw-r--r-- | docs/Config_Reference.md | 34 |
1 files changed, 34 insertions, 0 deletions
diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md index ded1f062..1c86acf5 100644 --- a/docs/Config_Reference.md +++ b/docs/Config_Reference.md @@ -3750,3 +3750,37 @@ I2C bus. # On some micro-controllers changing this value has no effect. The # default is 100000. ``` + +# Other Custom Modules + +## [palette2] + +Palette 2 multimaterial support - provides a tighter integration +supporting Palette 2 devices in connected mode. + +This modules also requires `[virtual_sdcard]` and `[pause_resume]` +for full functionality. + +If you use this module, do not use the Palette 2 plugin for +Octoprint as they will conflict, and 1 will fail to initialize +properly likely aborting your print. + +If you use Octoprint and stream gcode over the serial port instead of +printing from virtual_sd, then remo **M1** and **M0** from *Pausing commands* +in *Settings > Serial Connection > Firmware & protocol* will prevent +the need to start print on the Palette 2 and unpausing in Octoprint +for your print to begin. + +``` +[palette2] +serial: +# The serial port to connect to the Palette 2. +#baud: 250000 +# The baud rate to use. The default is 250000. +#feedrate_splice: 0.8 +# The feedrate to use when splicing, default is 0.8 +#feedrate_normal: 1.0 +# The feedrate to use after splicing, default is 1.0 +#auto_load_speed: 2 +# Extrude feedrate when autoloading, default is 2 (mm/s) +``` |