diff options
Diffstat (limited to 'docs/Config_Reference.md')
| -rw-r--r-- | docs/Config_Reference.md | 12 |
1 files changed, 11 insertions, 1 deletions
diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md index 6a5a7582..5d85e483 100644 --- a/docs/Config_Reference.md +++ b/docs/Config_Reference.md @@ -1790,11 +1790,14 @@ section of the measuring resonances guide for more information on # auto-calibration (with 'SHAPER_CALIBRATE' command). By default no # maximum smoothing is specified. Refer to Measuring_Resonances guide # for more details on using this feature. +#move_speed: 50 +# The speed (in mm/s) to move the toolhead to and between test points +# during the calibration. The default is 50. #min_freq: 5 # Minimum frequency to test for resonances. The default is 5 Hz. #max_freq: 133.33 # Maximum frequency to test for resonances. The default is 133.33 Hz. -#accel_per_hz: 75 +#accel_per_hz: 60 # This parameter is used to determine which acceleration to use to # test a specific frequency: accel = accel_per_hz * freq. Higher the # value, the higher is the energy of the oscillations. Can be set to @@ -1808,6 +1811,13 @@ section of the measuring resonances guide for more information on # hz_per_sec. Small values make the test slow, and the large values # will decrease the precision of the test. The default value is 1.0 # (Hz/sec == sec^-2). +#sweeping_accel: 400 +# An acceleration of slow sweeping moves. The default is 400 mm/sec^2. +#sweeping_period: 1.2 +# A period of slow sweeping moves. Setting this parameter to 0 +# disables slow sweeping moves. Avoid setting it to a too small +# non-zero value in order to not poison the measurements. +# The default is 1.2 sec which is a good all-round choice. ``` ## Config file helpers |