diff options
Diffstat (limited to 'docs/Config_Reference.md')
| -rw-r--r-- | docs/Config_Reference.md | 25 |
1 files changed, 18 insertions, 7 deletions
diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md index 14b89200..1b833eaf 100644 --- a/docs/Config_Reference.md +++ b/docs/Config_Reference.md @@ -97,13 +97,22 @@ max_accel: # will do so at the rate specified here. The value specified here # may be changed at runtime using the SET_VELOCITY_LIMIT command. # This parameter must be specified. -#max_accel_to_decel: -# A pseudo acceleration (in mm/s^2) controlling how fast the -# toolhead may go from acceleration to deceleration. It is used to -# reduce the top speed of short zig-zag moves (and thus reduce -# printer vibration from these moves). The value specified here may -# be changed at runtime using the SET_VELOCITY_LIMIT command. The -# default is half of max_accel. +#minimum_cruise_ratio: 0.5 +# Most moves will accelerate to a cruising speed, travel at that +# cruising speed, and then decelerate. However, some moves that +# travel a short distance could nominally accelerate and then +# immediately decelerate. This option reduces the top speed of these +# moves to ensure there is always a minimum distance traveled at a +# cruising speed. That is, it enforces a minimum distance traveled +# at cruising speed relative to the total distance traveled. It is +# intended to reduce the top speed of short zigzag moves (and thus +# reduce printer vibration from these moves). For example, a +# minimum_cruise_ratio of 0.5 would ensure that a standalone 1.5mm +# move would have a minimum cruising distance of 0.75mm. Specify a +# ratio of 0.0 to disable this feature (there would be no minimum +# cruising distance enforced between acceleration and deceleration). +# The value specified here may be changed at runtime using the +# SET_VELOCITY_LIMIT command. The default is 0.5. #square_corner_velocity: 5.0 # The maximum velocity (in mm/s) that the toolhead may travel a 90 # degree corner at. A non-zero value can reduce changes in extruder @@ -116,6 +125,8 @@ max_accel: # decelerate to zero at each corner. The value specified here may be # changed at runtime using the SET_VELOCITY_LIMIT command. The # default is 5mm/s. +#max_accel_to_decel: +# This parameter is deprecated and should no longer be used. ``` ### [stepper] |