diff options
Diffstat (limited to 'config')
| -rw-r--r-- | config/example-extras.cfg | 16 |
1 files changed, 8 insertions, 8 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index c62d9140..a99e9dc4 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -1441,10 +1441,10 @@ # If true, enable step interpolation (the driver will internally # step at a rate of 256 micro-steps). The default is True. #run_current: -# The amount of current (in amps) to configure the driver to use +# The amount of current (in amps RMS) to configure the driver to use # during stepper movement. This parameter must be provided. #hold_current: -# The amount of current (in amps) to configure the driver to use +# The amount of current (in amps RMS) to configure the driver to use # when the stepper is not moving. The default is to use the same # value as run_current. #sense_resistor: 0.110 @@ -1506,10 +1506,10 @@ # If true, enable step interpolation (the driver will internally # step at a rate of 256 micro-steps). The default is True. #run_current: -# The amount of current (in amps) to configure the driver to use +# The amount of current (in amps RMS) to configure the driver to use # during stepper movement. This parameter must be provided. #hold_current: -# The amount of current (in amps) to configure the driver to use +# The amount of current (in amps RMS) to configure the driver to use # when the stepper is not moving. The default is to use the same # value as run_current. #sense_resistor: 0.110 @@ -1615,8 +1615,8 @@ # step at a rate of 256 micro-steps). This only works if microsteps # is set to 16. The default is True. #run_current: -# The amount of current (in ampere) used by the driver during stepper -# movement. This parameter must be provided. +# The amount of current (in amps RMS) used by the driver during +# stepper movement. This parameter must be provided. #sense_resistor: # The resistance (in ohms) of the motor sense resistor. This parameter # must be provided. @@ -1680,10 +1680,10 @@ # If true, enable step interpolation (the driver will internally # step at a rate of 256 micro-steps). The default is True. #run_current: -# The amount of current (in amps) to configure the driver to use +# The amount of current (in amps RMS) to configure the driver to use # during stepper movement. This parameter must be provided. #hold_current: -# The amount of current (in amps) to configure the driver to use +# The amount of current (in amps RMS) to configure the driver to use # when the stepper is not moving. The default is to use the same # value as run_current. #sense_resistor: 0.075 |