diff options
Diffstat (limited to 'config')
| -rw-r--r-- | config/printer-anycubic-kossel-plus-2017.cfg | 41 |
1 files changed, 21 insertions, 20 deletions
diff --git a/config/printer-anycubic-kossel-plus-2017.cfg b/config/printer-anycubic-kossel-plus-2017.cfg index 09db805c..ff20c69e 100644 --- a/config/printer-anycubic-kossel-plus-2017.cfg +++ b/config/printer-anycubic-kossel-plus-2017.cfg @@ -19,7 +19,7 @@ homing_speed: 60 # and meassure the distance from nozzle to bed. # This value then needs to be added. position_endstop: 295.6 -arm_length: 271.50 +arm_length: 269.0 [stepper_b] step_pin: ar60 @@ -39,7 +39,7 @@ endstop_pin: ^ar19 step_pin: ar26 dir_pin: !ar28 enable_pin: !ar24 -step_distance: 0.010989 +step_distance: 0.0104166 nozzle_diameter: 0.400 filament_diameter: 1.750 heater_pin: ar10 @@ -53,13 +53,16 @@ min_extrude_temp: 150 min_temp: 0 max_temp: 275 -#[heater_bed] -#heater_pin: ar8 -#sensor_type: EPCOS 100K B57560G104F -#sensor_pin: analog14 -#control: watermark -#min_temp: 0 -#max_temp: 130 +[heater_bed] +heater_pin: ar8 +sensor_type: EPCOS 100K B57560G104F +sensor_pin: analog14 +control: pid +pid_kp: 73.517 +pid_ki: 1.132 +pid_kd: 1193.728 +min_temp: 0 +max_temp: 130 [fan] pin: ar9 @@ -68,6 +71,12 @@ kick_start_time: 0.200 [heater_fan extruder_cooler_fan] pin: ar44 +# if you want to use your probe for DELTA_CALIBRATE you will need that +#[probe] +#pin: ^ar18 +#z_offset: 15.9 +#samples: 3 + [mcu] serial: /dev/ttyUSB0 pin_map: arduino @@ -77,23 +86,15 @@ kinematics: delta max_velocity: 500 max_accel: 3000 max_z_velocity: 200 -delta_radius: 115 +delta_radius: 134.4 # if you want to DELTA_CALIBRATE you may need that #minimum_z_position: -5 [idle_timeout] timeout: 360 -#[delta_calibrate] -#radius: 115 -#manual_probe: -# If true, then DELTA_CALIBRATE will perform manual probing. If -# false, then a PROBE command will be run at each probe -# point. Manual probing is accomplished by manually jogging the Z -# position of the print head at each probe point and then issuing a -# NEXT extended g-code command to record the position at that -# point. The default is false if a [probe] config section is present -# and true otherwise. +[delta_calibrate] +radius: 115 # "RepRapDiscount 2004 Smart Controller" type displays [display] |