1 files changed, 77 insertions, 0 deletions
diff --git a/config/generic-bigtreetech-skr-mini.cfg b/config/generic-bigtreetech-skr-mini.cfg
new file mode 100644
index 00000000..44537f55
--- /dev/null
+++ b/config/generic-bigtreetech-skr-mini.cfg
@@ -0,0 +1,77 @@
+# This file contains common pin mappings for the BIGTREETECH SKR
+# MINI. To use this config, the firmware should be compiled for the
+# STM32F103 with a "28KiB bootloader".
+
+# The "make flash" command does not work on the SKR mini. Instead,
+# after running "make", copy the generated "out/klipper.bin" file to a
+# file named "firmware.bin" on an SD card and then restart the SKR
+# mini with that SD card.
+
+# See the example.cfg file for a description of available parameters.
+
+[stepper_x]
+step_pin: PC6
+dir_pin: PC7
+enable_pin: !PB15
+step_distance: .0025
+endstop_pin: PC2 # X+ is PA2
+position_endstop: 0
+position_max: 200
+homing_speed: 50
+
+[stepper_y]
+step_pin: PB13
+dir_pin: PB14
+enable_pin: !PB12
+step_distance: .0025
+endstop_pin: PC1 # Y+ is PA1
+position_endstop: 0
+position_max: 200
+homing_speed: 50
+
+[stepper_z]
+step_pin: PB10
+dir_pin: PB11
+enable_pin: !PB2
+step_distance: .0125
+endstop_pin: PC0 # Z+ is PC3
+position_endstop: 0.5
+position_max: 200
+
+[extruder]
+step_pin: PC5
+dir_pin: PB0
+enable_pin: !PC4
+step_distance: .002
+nozzle_diameter: 0.400
+filament_diameter: 1.750
+heater_pin: PA8
+sensor_type: EPCOS 100K B57560G104F
+sensor_pin: PA0
+control: pid
+pid_Kp: 22.2
+pid_Ki: 1.08
+pid_Kd: 114
+min_temp: 0
+max_temp: 250
+
+#[heater_bed]
+#heater_pin: PC9
+#sensor_type: ATC Semitec 104GT-2
+#sensor_pin: PB1
+#control: watermark
+#min_temp: 0
+#max_temp: 130
+
+[fan]
+pin: PC8
+
+[mcu]
+serial: /dev/serial/by-id/usb-Klipper_Klipper_firmware_12345-if00
+
+[printer]
+kinematics: cartesian
+max_velocity: 300
+max_accel: 3000
+max_z_velocity: 5
+max_z_accel: 100