diff options
Diffstat (limited to 'config/example.cfg')
| -rw-r--r-- | config/example.cfg | 11 |
1 files changed, 9 insertions, 2 deletions
diff --git a/config/example.cfg b/config/example.cfg index 9f89d5e0..af418ca6 100644 --- a/config/example.cfg +++ b/config/example.cfg @@ -153,6 +153,13 @@ filament_diameter: 3.500 heater_pin: ar4 # PWM output pin controlling the heater. This parameter must be # provided. +#max_power: 1.0 +# The maximum power (expressed as a value from 0.0 to 1.0) that the +# heater_pin may be set to. The value 1.0 allows the pin to be set +# fully enabled for extended periods, while a value of 0.5 would +# allow the pin to be enabled for no more than half the time. This +# setting may be used to limit the total power output (over extended +# periods) to the heater. The default is 1.0. thermistor_pin: analog1 # Analog input pin connected to thermistor. This parameter must be # provided. @@ -179,9 +186,9 @@ pid_Kd: 114 # A time value (in seconds) over which the derivative in the pid # will be smoothed to reduce the impact of measurement noise. The # default is 2 seconds. -#pid_integral_max: 255 +#pid_integral_max: # The maximum "windup" the integral term may accumulate. The default -# is 255. +# is to use the same value as max_power. #min_extrude_temp: 170 # The minimum temperature (in Celsius) at which extruder move # commands may be issued. The default is 170 Celsius. |