diff options
Diffstat (limited to 'config/example.cfg')
| -rw-r--r-- | config/example.cfg | 15 |
1 files changed, 10 insertions, 5 deletions
diff --git a/config/example.cfg b/config/example.cfg index cf02bf19..d8ca95fa 100644 --- a/config/example.cfg +++ b/config/example.cfg @@ -296,11 +296,16 @@ max_z_accel: 30 #motor_off_time: 600 # Time (in seconds) of idle time before the printer will try to # disable active motors. The default is 600 seconds. -#junction_deviation: 0.02 -# Distance (in mm) used to control the internal approximated -# centripetal velocity cornering algorithm. A larger number will -# permit higher "cornering speeds" at the junction of two moves. The -# default is 0.02mm. +#square_corner_velocity: 5.0 +# The maximum velocity (in mm/s) that the toolhead may travel a 90 +# degree corner at. A non-zero value can reduce changes in extruder +# flow rates by enabling instantaneous velocity changes of the +# toolhead during cornering. This value configures the internal +# centripetal velocity cornering algorithm; corners with angles +# larger than 90 degrees will have a higher cornering velocity while +# corners with angles less than 90 degrees will have a lower +# cornering velocity. If this is set to zero then the toolhead will +# decelerate to zero at each corner. The default is 5mm/s. # Looking for more options? Check the example-extras.cfg file. |