diff options
Diffstat (limited to 'config/example-extras.cfg')
| -rw-r--r-- | config/example-extras.cfg | 34 |
1 files changed, 34 insertions, 0 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 830381ce..7463051c 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -966,6 +966,40 @@ # The I2C speed (in Hz) to use when communicating with the sensor. Default # is 100000. On some MCUs changing this value has no effect. +# HTU21D family two wire interface (I2C) environmental sensor. +# Note that this sensor is not intended for use with extruders and heater beds, +# but rather for montitoring ambient temperature (C) and relative humidity. +# See sample-macros.cfg for a gcode_macro that may be used to report humidity +# in addition to temperature. +#[temperature_sensor my_sensor] +# See the "temperature_sensor" section below for a description of its +# parameters. The parameters below describe HTU21D family sensor parameters. +#sensor_type: +# Must be "HTU21D" , "SI7013", "SI7020", "SI7021" or "SHT21" +#i2c_address: +# Default is 64 (0x40). +#i2c_mcu: +# MCU the sensor is connected to. Default is the primary mcu. +#i2c_bus: +# The I2C bus the sensor is connected to. On some MCU platforms the default +# is bus 0. On platforms without bus 0 this parameter is required. +#i2c_speed: +# The I2C speed (in Hz) to use when communicating with the sensor. Default +# is 100000. On some MCUs changing this value has no effect. +#htu21d_hold_master: +# If the sensor can hold the I2C buf while reading. If True no other bus +# comunication can be performed while reading is in progress.Default is False +#htu21d_resolution: +# The resolution of temperature and humidity reading. +# Valid values are: +# 'TEMP14_HUM12' -> 14bit for Temp and 12bit for humidity +# 'TEMP13_HUM10' -> 13bit for Temp and 10bit for humidity +# 'TEMP12_HUM08' -> 12bit for Temp and 08bit for humidity +# 'TEMP11_HUM11' -> 11bit for Temp and 11bit for humidity +# Default is: "TEMP11_HUM11" +#htu21d_report_time: +# interval in seconds between readings. Default is 30 + # Generic heaters (one may define any number of sections with a # "heater_generic" prefix). These heaters behave similarly to standard # heaters (extruders, heated beds). Use the SET_HEATER_TEMPERATURE |