diff options
Diffstat (limited to 'config/example-extras.cfg')
| -rw-r--r-- | config/example-extras.cfg | 21 |
1 files changed, 21 insertions, 0 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 8ea42f0d..136ff1fa 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -821,6 +821,27 @@ # chips. The defaults for each parameter are next to the parameter # name in the above list. +# BME280 two wire interface (I2C) environmental sensor. Note that this +# sensor is not intended for use with extruders and heater beds, but rather +# for montitoring ambient temperature (C), pressure (hPa), and relative +# humidity. See sample-macros.cfg for a gcode_macro that may be used to report +# pressure and humidity in addition to temperature. +#[temperature_sensor my_sensor] +# See the "temperature_sensor" section below for a description of its +# parameters. The parameters below describe BME280 sensor parameters. +#sensor_type: +# Must be "BME280" +#i2c_address: +# Default is 118 (0x76). Some BME280 sensors have an address of 119 (0x77). +#i2c_mcu: +# MCU the sensor is connected to. Default is the primary mcu. +#i2c_bus: +# The I2C bus the sensor is connected to. On some MCU platforms the default +# is bus 0. On platforms without bus 0 this parameter is required. +#i2c_speed: +# The I2C speed (in Hz) to use when communicating with the sensor. Default +# is 100000. On some MCUs changing this value has no effect. + # Common temperature amplifiers. The following parameters are # available in heater sections that use one of these sensors. #[extruder] |