diff options
Diffstat (limited to 'config/example-extras.cfg')
| -rw-r--r-- | config/example-extras.cfg | 37 |
1 files changed, 19 insertions, 18 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index e3424eec..5140a1bf 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -322,33 +322,34 @@ # axis is triggered. -# Stepper phase adjusted endstops. The following additional parameters -# may be added to a stepper axis definition to improve the accuracy of -# endstop switches. -#[stepper_z] -#homing_stepper_phases: -# One may set this to the number of phases of the stepper motor -# driver (which is the number of micro-steps multiplied by -# four). This parameter must be provided if using stepper phase -# adjustments. -#homing_endstop_accuracy: 0.200 +# Stepper phase adjusted endstops. To use this feature, define a +# config section with an "endstop_phase" prefix followed by the name +# of the corresponding stepper config section (for example, +# "[endstop_phase stepper_z]"). This feature can improve the accuracy +# of endstop switches. +#[endstop_phase stepper_z] +#phases: +# Set this to the number of phases of the given stepper motor driver +# (which is the number of micro-steps multiplied by four). This +# parameter must be provided. +#endstop_accuracy: 0.200 # Sets the expected accuracy (in mm) of the endstop. This represents # the maximum error distance the endstop may trigger (eg, if an # endstop may occasionally trigger 100um early or up to 100um late # then set this to 0.200 for 200um). The default is -# homing_stepper_phases*step_distance. -#homing_endstop_phase: +# phases*step_distance. +#endstop_phase: # This specifies the phase of the stepper motor driver to expect # when hitting the endstop. Only set this value if one is sure the # stepper motor driver is reset every time the mcu is reset. If this # is not set, then the stepper phase will be detected on the first # home and that phase will be used on all subsequent homes. -#homing_endstop_align_zero: False -# If true then the code will arrange for the zero position on the -# axis to occur at a full step on the stepper motor. (If used on the -# Z axis and the print layer height is a multiple of a full step -# distance then every layer will occur on a full step.) The default -# is False. +#endstop_align_zero: False +# If true then the position_endstop of the axis will effectively be +# modified so that the zero position for the axis occurs at a full +# step on the stepper motor. (If used on the Z axis and the print +# layer height is a multiple of a full step distance then every +# layer will occur on a full step.) The default is False. # Heater cooling fans (one may define any number of sections with a |