diff options
Diffstat (limited to 'config/example-extras.cfg')
| -rw-r--r-- | config/example-extras.cfg | 34 |
1 files changed, 33 insertions, 1 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 987d5296..fc439f3a 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -680,6 +680,13 @@ # The pin corresponding to the AD5206 chip select line. This pin # will be set to low at the start of SPI messages and raised to high # after the message completes. This parameter must be provided. +#spi_bus: +#spi_speed: +#spi_software_sclk_pin: +#spi_software_mosi_pin: +#spi_software_miso_pin: +# These optional parameters allow one to customize the SPI settings +# used to communicate with the chip. #channel_1: #channel_2: #channel_3: @@ -787,6 +794,13 @@ # The pin corresponding to the TMC2130 chip select line. This pin # will be set to low at the start of SPI messages and raised to high # after the message completes. This parameter must be provided. +#spi_bus: +#spi_speed: +#spi_software_sclk_pin: +#spi_software_mosi_pin: +#spi_software_miso_pin: +# These optional parameters allow one to customize the SPI settings +# used to communicate with the chip. #microsteps: # The number of microsteps to configure the driver to use. Valid # values are 1, 2, 4, 8, 16, 32, 64, 128, 256. This parameter must @@ -908,6 +922,11 @@ #spi_speed: 2000000 # SPI bus frequency used to communicate with the TMC2660 stepper # driver. The default is 2000000. +#spi_software_sclk_pin: +#spi_software_mosi_pin: +#spi_software_miso_pin: +# These optional parameters allow one to customize the SPI settings +# used to communicate with the chip. #microsteps: # The number of microsteps to configure the driver to use. Valid # values are 1, 2, 4, 8, 16, 32, 64, 128, 256. This parameter must @@ -1043,8 +1062,15 @@ # provided when using an uc1701 display. #cs_pin: #dc_pin: +#spi_bus: +#spi_speed: +#spi_software_sclk_pin: +#spi_software_mosi_pin: +#spi_software_miso_pin: # The pins connected to an ssd1306 type lcd when in "4-wire" spi -# mode. The default is to use i2c mode for ssd1306 displays. +# mode. The parameters that start with "spi_" are optional and they +# control the spi settings used to communicate with the chip. The +# default is to use i2c mode for ssd1306 displays. #menu_root: # Entry point for menu, root menu container name. If this parameter # is not provided then default menu root is used. When provided @@ -1140,6 +1166,12 @@ #spi_speed: 4000000 # The SPI speed (in hz) to use when communicating with the chip. # The default is 4000000. +#spi_bus: +#spi_software_sclk_pin: +#spi_software_mosi_pin: +#spi_software_miso_pin: +# These optional parameters allow one to customize the SPI settings +# used to communicate with the chip. #sensor_pin: # The chip select line for the sensor chip. This parameter must be # provided. |