diff options
Diffstat (limited to 'config/example-extras.cfg')
| -rw-r--r-- | config/example-extras.cfg | 41 |
1 files changed, 39 insertions, 2 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 806b5f7d..d22311a3 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -107,8 +107,8 @@ # is above the bed at the given nozzle coordinates. The default is # to not enable the command. #speed: 50 -# The speed (in mm/s) of non-probing moves during the -# calibration. The default is 50. +# The speed (in mm/s) of non-probing moves during the calibration. +# The default is 50. #horizontal_move_z: 5 # The height (in mm) that the head should be commanded to move to # just prior to starting a probe operation. The default is 5. @@ -226,6 +226,43 @@ # results in more curvature in the mesh. Default is .2. +# Tool to help adjust bed leveling screws. One may define a +# [bed_screws] config section to enable a BED_SCREWS_ADJUST g-code +# command. +#[bed_screws] +#screw1: 100,100 +# The X,Y coordinate of the first bed leveling screw. This is a +# position to command the nozzle to that is directly above the bed +# screw (or as close as possible while still being above the bed). +# This parameter must be provided. +#screw1_name: front screw +# An arbitrary name for the given screw. This name is displayed when +# the helper script runs. The default is to use a name based upon +# the screw XY location. +#screw1_fine_adjust: +# An X,Y coordinate to command the nozzle to so that one can fine +# tune the bed leveling screw. The default is to not perform fine +# adjustments on the bed screw. +#screw2: +#screw2_name: +#screw2_fine_adjust: +#... +# Additional bed leveling screws. At least three screws must be +# defined. +#horizontal_move_z: 5 +# The height (in mm) that the head should be commanded to move to +# when moving from one screw location to the next. The default is 5. +#probe_height: 0 +# The height of the probe (in mm) after adjusting for the thermal +# expansion of bed and nozzle. The default is zero. +#speed: 50 +# The speed (in mm/s) of non-probing moves during the calibration. +# The default is 50. +#probe_speed: 5 +# The speed (in mm/s) when moving from a horizontal_move_z position +# to a probe_height position. The default is 5. + + # Multiple Z stepper tilt adjustment. This feature enables independent # adjustment of multiple z steppers (see stepper_z1 section below) to # adjust for tilt. If this section is present then a Z_TILT_ADJUST |