diff options
Diffstat (limited to 'config/example-extras.cfg')
| -rw-r--r-- | config/example-extras.cfg | 24 |
1 files changed, 17 insertions, 7 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 318669d2..1f4bc793 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -99,7 +99,10 @@ # Mesh Bed Leveling. One may define a [bed_mesh] config section # to enable move transformations that offset the z axis based # on a mesh generated from probed points. Note that bed_mesh -# and bed_tilt are incompatible, both cannot be defined. +# and bed_tilt are incompatible, both cannot be defined. When +# using a probe to home the z-axis, it is recommended to define +# a [homing_override] section in printer.cfg to home toward the +# center of the print area. #[bed_mesh] #speed: 50 # The speed (in mm/s) of non-probing moves during the @@ -129,12 +132,19 @@ # in which case that value will be for both axes. Default is 3,3 # which probes a 3x3 grid. #fade_start: 1.0 -# The z-axis position in which to start phasing z-adjustment out. -# Default is 1.0. -#fade_end: 10.0 -# The z-axis position in which phase out is complete. If this -# value is less than or equal to fade_start then phasing out -# is disabled. Default is 10.0. +# The gcode z position in which to start phasing out z-adjustment +# when fade is enabled. Default is 1.0. +#fade_end: 0.0 +# The gcode z position in which phasing out completes. When set +# to a value below fade_start, fade is disabled. It should be +# noted that fade may add unwanted scaling along the z-axis of a +# print. If a user wishes to enable fade, a value of 10.0 is +# recommended. Default is 0.0, which disables fade. +#fade_target: +# The z position in which fade should converge. When this value is set +# to a non-zero value it must be within the range of z-values in the mesh. +# Users that wish to converge to the z homing position should set this to 0. +# Default is the average z value of the mesh. #split_delta_z: .025 # The amount of Z difference (in mm) along a move that will # trigger a split. Default is .025. |