diff options
Diffstat (limited to 'config/example-extras.cfg')
| -rw-r--r-- | config/example-extras.cfg | 35 |
1 files changed, 35 insertions, 0 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index 70dc1c1f..23806689 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -17,6 +17,41 @@ # command. The default is 0. +# Bed tilt compensation. One may define a [bed_tilt] config section to +# enable move transformations that account for a tilted bed. +#[bed_tilt] +#x_adjust: 0 +# The amount to add to each move's Z height for each mm on the X +# axis. The default is 0. +#y_adjust: 0 +# The amount to add to each move's Z height for each mm on the Y +# axis. The default is 0. +# The remaining parameters control a BED_TILT_CALIBRATE extended +# g-code command that may be used to calibrate appropriate x and y +# adjustment parameters. +#points: +# A newline separated list of X,Y points that should be probed +# during a BED_TILT_CALIBRATE command. The default is to not enable +# the command. +#speed: 50 +# The speed (in mm/s) of non-probing moves during the +# calibration. The default is 50. +#horizontal_move_z: 5 +# The height (in mm) that the head should be commanded to move to +# just prior to starting a probe operation. The default is 5. +#probe_z_offset: 0 +# The Z height (in mm) of the head when the probe triggers. The +# default is 0. +#manual_probe: +# If true, then BED_TILT_CALIBRATE will perform manual probing. If +# false, then a PROBE command will be run at each probe +# point. Manual probing is accomplished by manually jogging the Z +# position of the print head at each probe point and then issuing a +# NEXT extended g-code command to record the position at that +# point. The default is false if a [probe] config section is present +# and true otherwise. + + # In a multi-extruder printer add an additional extruder section for # each additional extruder. The additional extruder sections should be # named "extruder1", "extruder2", "extruder3", and so on. See the |