diff options
| -rw-r--r-- | docs/Measuring_Resonances.md | 9 |
1 files changed, 5 insertions, 4 deletions
diff --git a/docs/Measuring_Resonances.md b/docs/Measuring_Resonances.md index 17a37562..cf43e31d 100644 --- a/docs/Measuring_Resonances.md +++ b/docs/Measuring_Resonances.md @@ -219,12 +219,13 @@ of time, up to 10-20 minutes. Be patient and wait for the completion of the installation. On some occasions, if the board has too little RAM the installation may fail and you will need to enable swap. -Afterwards, check and follow the instructions in the -[RPi Microcontroller document](RPi_microcontroller.md) to setup the -"linux mcu" on the Raspberry Pi. - #### Configure ADXL345 With RPi +First, check and follow the instructions in the +[RPi Microcontroller document](RPi_microcontroller.md) to setup the +"linux mcu" on the Raspberry Pi. This will configure a second Klipper +instance that runs on your Pi. + Make sure the Linux SPI driver is enabled by running `sudo raspi-config` and enabling SPI under the "Interfacing options" menu. |