diff options
| -rw-r--r-- | docs/Bootloaders.md | 8 |
1 files changed, 4 insertions, 4 deletions
diff --git a/docs/Bootloaders.md b/docs/Bootloaders.md index 40c1acd2..03ef4969 100644 --- a/docs/Bootloaders.md +++ b/docs/Bootloaders.md @@ -264,8 +264,8 @@ stm32flash -w out/klipper.bin -v -g 0 /dev/ttyAMA0 Note that if one is using a Raspberry Pi for the 3.3V serial, the stm32flash protocol uses a serial parity mode which the Raspberry Pi's -"miniuart" does not support. See -[https://www.raspberrypi.org/documentation/configuration/uart.md](https://www.raspberrypi.org/documentation/configuration/uart.md) +"mini UART" does not support. See +[https://www.raspberrypi.com/documentation/computers/configuration.html#configuring-uarts](https://www.raspberrypi.com/documentation/computers/configuration.html#configuring-uarts) for details on enabling the full uart on the Raspberry Pi GPIO pins. After flashing, set both "boot 0" and "boot 1" back to low so that @@ -301,7 +301,7 @@ while it is running). Alternatively, set the "boot 0" pin to low and The [HID bootloader](https://github.com/Serasidis/STM32_HID_Bootloader) is a compact, driverless bootloader capable of flashing over USB. Also available is a [fork with builds specific to the SKR Mini E3 1.2]( - https://github.com/Arksine/STM32_HID_Bootloader/releases/tag/v0.5-beta). + https://github.com/Arksine/STM32_HID_Bootloader/releases/latest). For generic STM32F103 boards such as the blue pill it is possible to flash the bootloader via 3.3v serial using stm32flash as noted in the stm32duino @@ -395,7 +395,7 @@ bootloader. The HID bootloader is available for STM32F405/407 based boards should the user prefer flashing over USB over using the sdcard. Note that you may need to configure and build a version specific to your board, a [build for the SKR Pro 1.1 is available here]( - https://github.com/Arksine/STM32_HID_Bootloader/releases/tag/v0.5-beta). + https://github.com/Arksine/STM32_HID_Bootloader/releases/latest). Unless your board is DFU capable the most accessable flashing method is likely via 3.3v serial, which follows the same procedure as |