diff options
| -rw-r--r-- | config/generic-printrboard.cfg | 76 |
1 files changed, 76 insertions, 0 deletions
diff --git a/config/generic-printrboard.cfg b/config/generic-printrboard.cfg new file mode 100644 index 00000000..25b07dca --- /dev/null +++ b/config/generic-printrboard.cfg @@ -0,0 +1,76 @@ +# This file contains common pin mappings for Printrboard boards (rev B +# through D). To use this config the firmware should be compiled for +# the AVR at90usb1286. + +# Note that the "make flash" command is unlikely to work on the +# Printrboard. See the RepRap Printrboard wiki page for instructions +# on flashing. + +# See the example.cfg file for a description of available parameters. + +[stepper_x] +step_pin: PA0 +dir_pin: !PA1 +enable_pin: !PE7 +step_distance: .0125 +endstop_pin: ^PE3 +position_endstop: 0 +position_max: 200 +homing_speed: 50 + +[stepper_y] +step_pin: PA2 +dir_pin: PA3 +enable_pin: !PE6 +step_distance: .0125 +endstop_pin: ^PB0 +position_endstop: 0 +position_max: 200 +homing_speed: 50 + +[stepper_z] +step_pin: PA4 +dir_pin: !PA5 +enable_pin: !PC7 +step_distance: 0.00025 +endstop_pin: ^PE4 +position_endstop: 0.5 +position_max: 200 + +[extruder] +step_pin: PA6 +dir_pin: PA7 +enable_pin: !PC3 +step_distance: .002 +nozzle_diameter: 0.400 +filament_diameter: 1.750 +heater_pin: PC5 +sensor_type: EPCOS 100K B57560G104F +sensor_pin: PF1 +control: pid +pid_Kp: 22.2 +pid_Ki: 1.08 +pid_Kd: 114 +min_temp: 0 +max_temp: 250 + +[heater_bed] +heater_pin: PC4 +sensor_type: EPCOS 100K B57560G104F +sensor_pin: PF0 +control: watermark +min_temp: 0 +max_temp: 130 + +[fan] +pin: PC6 + +[mcu] +serial: /dev/ttyACM0 + +[printer] +kinematics: cartesian +max_velocity: 300 +max_accel: 3000 +max_z_velocity: 5 +max_z_accel: 100 |