diff options
| -rw-r--r-- | docs/Axis_Twist_Compensation.md | 24 |
1 files changed, 12 insertions, 12 deletions
diff --git a/docs/Axis_Twist_Compensation.md b/docs/Axis_Twist_Compensation.md index b0c80b18..b840fe3d 100644 --- a/docs/Axis_Twist_Compensation.md +++ b/docs/Axis_Twist_Compensation.md @@ -1,6 +1,6 @@ # Axis Twist Compensation -This document describes the [axis_twist_compensation] module. +This document describes the `[axis_twist_compensation]` module. Some printers may have a small twist in their X rail which can skew the results of a probe attached to the X carriage. @@ -25,31 +25,31 @@ try to probe the bed without attaching the probe if you use it. > correctly set as they greatly influence calibration. ### Basic Usage: X-Axis Calibration -1. After setting up the ```[axis_twist_compensation]``` module, run: +1. After setting up the `[axis_twist_compensation]` module, run: ``` AXIS_TWIST_COMPENSATION_CALIBRATE ``` This command will calibrate the X-axis by default. - - The calibration wizard will prompt you to measure the probe Z offset at + - The calibration wizard will prompt you to measure the probe Z offset at several points along the bed. - - By default, the calibration uses 3 points, but you can specify a different + - By default, the calibration uses 3 points, but you can specify a different number with the option: `` SAMPLE_COUNT=<value> `` 2. **Adjust Your Z Offset:** -After completing the calibration, be sure to [adjust your Z offset] -(Probe_Calibrate.md#calibrating-probe-z-offset). +After completing the calibration, be sure to +[adjust your Z offset](Probe_Calibrate.md#calibrating-probe-z-offset). 3. **Perform Bed Leveling Operations:** Use probe-based operations as needed, such as: - - [Screws Tilt Adjust](G-Codes.md#screws_tilt_adjust) - - [Z Tilt Adjust](G-Codes.md#z_tilt_adjust) + - [Screws Tilt Adjust](G-Codes.md#screws_tilt_adjust) + - [Z Tilt Adjust](G-Codes.md#z_tilt_adjust) 4. **Finalize the Setup:** - - Home all axes, and perform a [Bed Mesh](Bed_Mesh.md) if necessary. - - Run a test print, followed by any + - Home all axes, and perform a [Bed Mesh](Bed_Mesh.md) if necessary. + - Run a test print, followed by any [fine-tuning](Axis_Twist_Compensation.md#fine-tuning) if needed. @@ -75,8 +75,8 @@ In this mode, the calibration process will run for both axes automatically. ## [axis_twist_compensation] setup and commands -Configuration options for [axis_twist_compensation] can be found in the +Configuration options for `[axis_twist_compensation]` can be found in the [Configuration Reference](Config_Reference.md#axis_twist_compensation). -Commands for [axis_twist_compensation] can be found in the +Commands for `[axis_twist_compensation]` can be found in the [G-Codes Reference](G-Codes.md#axis_twist_compensation) |