diff options
| -rw-r--r-- | docs/G-Codes.md | 14 |
1 files changed, 7 insertions, 7 deletions
diff --git a/docs/G-Codes.md b/docs/G-Codes.md index b0c0d770..6dc5df8b 100644 --- a/docs/G-Codes.md +++ b/docs/G-Codes.md @@ -94,13 +94,13 @@ acceleration (+/- some noise of the chip). #### ACCELEROMETER_DEBUG_READ `ACCELEROMETER_DEBUG_READ [CHIP=<config_name>] REG=<register>`: -queries ADXL345 register <register> (e.g. 44 or 0x2C). Can be useful +queries ADXL345 register "register" (e.g. 44 or 0x2C). Can be useful for debugging purposes. #### ACCELEROMETER_DEBUG_WRITE -`ACCELEROMETER_DEBUG_WRITE [CHIP=<config_name>] REG=<reg> -VAL=<value>`: Writes raw <value> into a register <register>. Both -<value> and <register> can be a decimal or a hexadecimal integer. Use +`ACCELEROMETER_DEBUG_WRITE [CHIP=<config_name>] REG=<register> +VAL=<value>`: Writes raw "value" into a register "register". Both +"value" and "register" can be a decimal or a hexadecimal integer. Use with care, and refer to ADXL345 data sheet for the reference. ### [bed_mesh] @@ -326,7 +326,7 @@ enabled. #### SET_FAN_SPEED `SET_FAN_SPEED FAN=config_name SPEED=<speed>` This command sets the -speed of a fan. <speed> must be between 0.0 and 1.0. +speed of a fan. "speed" must be between 0.0 and 1.0. ### [firmware_retraction] @@ -832,9 +832,9 @@ all enabled accelerometer chips. `TEST_RESONANCES AXIS=<axis> OUTPUT=<resonances,raw_data> [NAME=<name>] [FREQ_START=<min_freq>] [FREQ_END=<max_freq>] [HZ_PER_SEC=<hz_per_sec>] [INPUT_SHAPING=[<0:1>]]`: Runs the resonance -test in all configured probe points for the requested <axis> and +test in all configured probe points for the requested "axis" and measures the acceleration using the accelerometer chips configured for -the respective axis. <axis> can either be X or Y, or specify an +the respective axis. "axis" can either be X or Y, or specify an arbitrary direction as `AXIS=dx,dy`, where dx and dy are floating point numbers defining a direction vector (e.g. `AXIS=X`, `AXIS=Y`, or `AXIS=1,-1` to define a diagonal direction). Note that `AXIS=dx,dy` |