diff options
| -rw-r--r-- | docs/TMC_Drivers.md | 18 |
1 files changed, 9 insertions, 9 deletions
diff --git a/docs/TMC_Drivers.md b/docs/TMC_Drivers.md index 6c90268b..38a9514a 100644 --- a/docs/TMC_Drivers.md +++ b/docs/TMC_Drivers.md @@ -437,15 +437,15 @@ Some common errors and tips for diagnosing them: #### TMC reports error: `... ot=1(OvertempError!)` -This indicates the motor driver disabled itself because it became too hot. Typical -solutions are to decrease the stepper motor current, increase cooling -on the stepper motor driver, and/or increase cooling on the stepper -motor. +This indicates the motor driver disabled itself because it became too +hot. Typical solutions are to decrease the stepper motor current, +increase cooling on the stepper motor driver, and/or increase cooling +on the stepper motor. #### TMC reports error: `... ShortToGND` OR `LowSideShort` -This indicates the driver has disabled itself because it detected very high -current passing through the driver. This may indicate a loose or +This indicates the driver has disabled itself because it detected very +high current passing through the driver. This may indicate a loose or shorted wire to the stepper motor or within the stepper motor itself. This error may also occur if using stealthChop mode and the TMC driver @@ -455,10 +455,10 @@ current through the motor and trigger its own over-current detection.) To test this, disable stealthChop mode and check if the errors continue to occur. -#### TMC reports error: `... reset=1(Reset)` OR `CS_ACTUAL=0(Reset?)**OR **SE=0(Reset?)` +#### TMC reports error: `... reset=1(Reset)` OR `CS_ACTUAL=0(Reset?)` OR `SE=0(Reset?)` -This indicates that the driver has reset itself -mid-print. This may be due to voltage or wiring issues. +This indicates that the driver has reset itself mid-print. This may be +due to voltage or wiring issues. #### TMC reports error: `... uv_cp=1(Undervoltage!)` |