diff options
| -rw-r--r-- | docs/Config_Reference.md | 15 |
1 files changed, 7 insertions, 8 deletions
diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md index fa770408..e16007fe 100644 --- a/docs/Config_Reference.md +++ b/docs/Config_Reference.md @@ -4343,12 +4343,6 @@ i2c_address: #i2c_speed: # See the "common I2C settings" section for a description of the # above parameters. -#i2c_bus: -#i2c_software_scl_pin: -#i2c_software_sda_pin: -# If the I2C implementation of your micro-controller supports -# multiple I2C busses, you may specify the bus name here. The -# default is to use the default micro-controller i2c bus. ``` ### [samd_sercom] @@ -4595,11 +4589,16 @@ via the `i2c_speed` parameter. All other Klipper micro-controllers use a # The name of the micro-controller that the chip is connected to. # The default is "mcu". #i2c_bus: -#i2c_software_scl_pin: -#i2c_software_sda_pin: # If the micro-controller supports multiple I2C busses then one may # specify the micro-controller bus name here. The default depends on # the type of micro-controller. +#i2c_software_scl_pin: +#i2c_software_sda_pin: +# Specify these parameters to use micro-controller software based +# I2C "bit-banging" support. The two parameters should the two pins +# on the micro-controller to use for the scl and sda wires. The +# default is to use hardware based I2C support as specified by the +# i2c_bus parameter. #i2c_speed: # The I2C speed (in Hz) to use when communicating with the device. # The Klipper implementation on most micro-controllers is hard-coded |