diff options
| -rw-r--r-- | config/printer-anycubic-4maxpro-2.0-2021.cfg | 49 |
1 files changed, 48 insertions, 1 deletions
diff --git a/config/printer-anycubic-4maxpro-2.0-2021.cfg b/config/printer-anycubic-4maxpro-2.0-2021.cfg index 75d32411..e0c83b6a 100644 --- a/config/printer-anycubic-4maxpro-2.0-2021.cfg +++ b/config/printer-anycubic-4maxpro-2.0-2021.cfg @@ -11,7 +11,7 @@ # For Anycubic 4Max Pro (not 2.0) owners: # Be careful when using this config! This config tested only on Anycubic -# 4Max Pro 2.0 with klipper v0.9.1-667-g31761500! At first, you should +# 4Max Pro 2.0! At first, you should # set homing_speed on 5, and run homing and click on the endstops with # your fingers. It is necessary to make sure that all the motors are # spinning in the right direction, all the temperature sensors show the @@ -139,3 +139,50 @@ screw4: 265, 5 [filament_switch_sensor filament_sensor] switch_pin: ^!PC4 + +[output_pin buzz] +pin: PC6 +pwm: True + +[output_pin AUTO_POWEROFF] +pin: PD0 +pwm: True +cycle_time: 0.02 +value: 1 + + +# This macro (M300) uses internal integrated beeper +# Just use it in your G-code for making sounds. Example: M300 S1000 P500 +[gcode_macro M300] +gcode: + {% set S = params.S|default(800)|float %} + {% set P = params.P|default(100)|int %} + SET_PIN PIN=buzz VALUE=0.5 CYCLE_TIME={ 1.0 / S | float } + G4 P{P} + SET_PIN PIN=buzz VALUE=0 + +# This macro (M81) uses internal integrated PSU control-relay. +# Just use M81 in your end_gcode if you want to poweroff your printer after print. +# Note: as in original Marlin firmware, before powerdown, printer will be cool hotend +# until temperature will be below 45°С / 113°F. + +[gcode_macro M81] +gcode: + {% set required_extruder_temp = params.T|default(45)|int %} + {% if printer.extruder.temperature > required_extruder_temp|default(45)|int %} + M300 + M300 + M300 + M117 COOLING DOWN BEFORE POWER OFF + M109 S{required_extruder_temp} + SET_PIN PIN=AUTO_POWEROFF VALUE=0.5 + G4 P60 + SET_PIN PIN=AUTO_POWEROFF VALUE=1 + {% else %} + M300 + M117 POWER OFF SOON + G4 P10000 + SET_PIN PIN=AUTO_POWEROFF VALUE=0.5 + G4 P60 + SET_PIN PIN=AUTO_POWEROFF VALUE=1 + {% endif %} |