diff options
| author | Andy Silverman <andrewsi@outlook.com> | 2017-12-30 15:43:03 -0800 |
|---|---|---|
| committer | Kevin O'Connor <kevin@koconnor.net> | 2018-01-03 12:32:11 -0500 |
| commit | b22a81cd3469bf8621f7467a171e784eea7b706f (patch) | |
| tree | cbd5ed6c9ec4fe33a6fb1f05c8928addb2305cd1 /klippy | |
| parent | 9fc5506c83691cd0b8e422839eb9fc048d0e05b6 (diff) | |
| download | kutter-b22a81cd3469bf8621f7467a171e784eea7b706f.tar.gz kutter-b22a81cd3469bf8621f7467a171e784eea7b706f.tar.xz kutter-b22a81cd3469bf8621f7467a171e784eea7b706f.zip | |
heater: Added config for heater PWM cycle time.
Added the pwm_cycle_time option for heater config sections. Defaults
to previous value of 0.100 seconds, but may be reduced to shorter times
at the expense of MCU workload and possible MOSFET heating, depending on
controller design. Some printers that need bed PID to be enabled,
notably the Felixprinters series, are known to benefit from shorter
cycle times, as the default 10hz rate results in excessive voltage
supply droop.
While this option can be used on extruder heaters as well, there
is not expected to be any particular benefit from doing so unless
the extruder heater presents a particularly large load.
Signed-off-by: Andy Silverman <andrewsi@outlook.com>
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Diffstat (limited to 'klippy')
| -rw-r--r-- | klippy/heater.py | 5 |
1 files changed, 3 insertions, 2 deletions
diff --git a/klippy/heater.py b/klippy/heater.py index 553b208b..83e8cf7c 100644 --- a/klippy/heater.py +++ b/klippy/heater.py @@ -95,7 +95,6 @@ Sensors = { SAMPLE_TIME = 0.001 SAMPLE_COUNT = 8 REPORT_TIME = 0.300 -PWM_CYCLE_TIME = 0.100 MAX_HEAT_TIME = 5.0 AMBIENT_TEMP = 25. PID_PARAM_BASE = 255. @@ -125,7 +124,9 @@ class PrinterHeater: self.mcu_pwm = pins.setup_pin(printer, 'digital_out', heater_pin) else: self.mcu_pwm = pins.setup_pin(printer, 'pwm', heater_pin) - self.mcu_pwm.setup_cycle_time(PWM_CYCLE_TIME) + pwm_cycle_time = config.getfloat( + 'pwm_cycle_time', 0.100, above=0., maxval=REPORT_TIME) + self.mcu_pwm.setup_cycle_time(pwm_cycle_time) self.mcu_pwm.setup_max_duration(MAX_HEAT_TIME) self.mcu_adc = pins.setup_pin(printer, 'adc', config.get('sensor_pin')) adc_range = [self.sensor.calc_adc(self.min_temp), |