docs: Add lis2dw i2c and lis3dh

Signed-off-by: Luke Vuksta <wulfstawulfsta@gmail.com>

1 files changed, 43 insertions, 2 deletions

diff --git a/docs/Config_Reference.md b/docs/Config_Reference.md
index 94379a75..17b466b3 100644
--- a/docs/Config_Reference.md
+++ b/docs/Config_Reference.md
@@ -1675,8 +1675,40 @@ Support for LIS2DW accelerometers.
 
 ```
 [lis2dw]
-cs_pin:
-#   The SPI enable pin for the sensor. This parameter must be provided.
+#cs_pin:
+#   The SPI enable pin for the sensor. This parameter must be provided
+#   if using SPI.
+#spi_speed: 5000000
+#   The SPI speed (in hz) to use when communicating with the chip.
+#   The default is 5000000.
+#spi_bus:
+#spi_software_sclk_pin:
+#spi_software_mosi_pin:
+#spi_software_miso_pin:
+#   See the "common SPI settings" section for a description of the
+#   above parameters.
+#i2c_address:
+#   Default is 25 (0x19). If SA0 is high, it would be 24 (0x18) instead.
+#i2c_mcu:
+#i2c_bus:
+#i2c_software_scl_pin:
+#i2c_software_sda_pin:
+#i2c_speed: 400000
+#   See the "common I2C settings" section for a description of the
+#   above parameters. The default "i2c_speed" is 400000.
+#axes_map: x, y, z
+#   See the "adxl345" section for information on this parameter.
+```
+
+### [lis3dh]
+
+Support for LIS3DH accelerometers.
+
+```
+[lis3dh]
+#cs_pin:
+#   The SPI enable pin for the sensor. This parameter must be provided
+#   if using SPI.
 #spi_speed: 5000000
 #   The SPI speed (in hz) to use when communicating with the chip.
 #   The default is 5000000.
@@ -1686,6 +1718,15 @@ cs_pin:
 #spi_software_miso_pin:
 #   See the "common SPI settings" section for a description of the
 #   above parameters.
+#i2c_address:
+#   Default is 25 (0x19). If SA0 is high, it would be 24 (0x18) instead.
+#i2c_mcu:
+#i2c_bus:
+#i2c_software_scl_pin:
+#i2c_software_sda_pin:
+#i2c_speed: 400000
+#   See the "common I2C settings" section for a description of the
+#   above parameters. The default "i2c_speed" is 400000.
 #axes_map: x, y, z
 #   See the "adxl345" section for information on this parameter.
 ```