diff options
| author | Kevin O'Connor <kevin@koconnor.net> | 2018-04-20 13:15:03 -0400 |
|---|---|---|
| committer | Kevin O'Connor <kevin@koconnor.net> | 2018-04-20 13:15:03 -0400 |
| commit | 85e6cd865c7e6e053971cac456155e5fbd97ccd6 (patch) | |
| tree | 6f30ac3573561d58cb87a2ee0fe8847e705b149c /config | |
| parent | 48e9fa04e78e4c57fbd558281170d16ab357377f (diff) | |
| download | kutter-85e6cd865c7e6e053971cac456155e5fbd97ccd6.tar.gz kutter-85e6cd865c7e6e053971cac456155e5fbd97ccd6.tar.xz kutter-85e6cd865c7e6e053971cac456155e5fbd97ccd6.zip | |
fan: Scale fan speed requests between 0 and max_power
If the fan's max power is limited by the config, then scale speed
requests between 0 and max_power. This makes more sense for typical
g-code fan speeds.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Diffstat (limited to 'config')
| -rw-r--r-- | config/example-extras.cfg | 4 | ||||
| -rw-r--r-- | config/example.cfg | 5 |
2 files changed, 6 insertions, 3 deletions
diff --git a/config/example-extras.cfg b/config/example-extras.cfg index c1370eda..8a26f50c 100644 --- a/config/example-extras.cfg +++ b/config/example-extras.cfg @@ -205,10 +205,10 @@ #heater_temp: 50.0 # A temperature (in Celsius) that the heater must drop below before # the fan is disabled. The default is 50 Celsius. -#fan_speed: +#fan_speed: 1.0 # The fan speed (expressed as a value from 0.0 to 1.0) that the fan # will be set to when its associated heater is enabled. The default -# is max_power. +# is 1.0 # Additional micro-controllers (one may define any number of sections diff --git a/config/example.cfg b/config/example.cfg index aacd4c99..f4c7029b 100644 --- a/config/example.cfg +++ b/config/example.cfg @@ -224,7 +224,10 @@ pin: ar9 # enabled for extended periods, while a value of 0.5 would allow the # pin to be enabled for no more than half the time. This setting may # be used to limit the total power output (over extended periods) to -# the fan. The default is 1.0. +# the fan. If this value is less than 1.0 then fan speed requests +# will be scaled between zero and max_power (for example, if +# max_power is .9 and a fan speed of 80% is requested then the fan +# power will be set to 72%). The default is 1.0. #cycle_time: 0.010 # The amount of time (in seconds) for each PWM power cycle to the # fan. It is recommended this be 10 milliseconds or greater when |