diff options
| author | Kevin O'Connor <kevin@koconnor.net> | 2018-11-13 14:32:52 -0500 |
|---|---|---|
| committer | Kevin O'Connor <kevin@koconnor.net> | 2018-11-13 14:32:52 -0500 |
| commit | 077280bb62adcbaeaf36b827a9de7f0e24d06e12 (patch) | |
| tree | 83d4b17e2ee368372bdf52f78875888fdfd07047 /config/printer-creality-cr10-2017.cfg | |
| parent | 5f9ce32fae034288e13a698b94b4fe69efd35ecf (diff) | |
| download | kutter-077280bb62adcbaeaf36b827a9de7f0e24d06e12.tar.gz kutter-077280bb62adcbaeaf36b827a9de7f0e24d06e12.tar.xz kutter-077280bb62adcbaeaf36b827a9de7f0e24d06e12.zip | |
config: Use consistent advice on flashing the Melzi board
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Diffstat (limited to 'config/printer-creality-cr10-2017.cfg')
| -rw-r--r-- | config/printer-creality-cr10-2017.cfg | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/config/printer-creality-cr10-2017.cfg b/config/printer-creality-cr10-2017.cfg index e44f82f6..257efa4b 100644 --- a/config/printer-creality-cr10-2017.cfg +++ b/config/printer-creality-cr10-2017.cfg @@ -2,12 +2,12 @@ # CR-10. To use this config, the firmware should be compiled for the # AVR atmega1284p. -# Note, a number of Melzi boards are shipped without a bootloader. In -# that case, an external programmer will be needed to flash a -# bootloader to the board (for example, see -# http://www.instructables.com/id/Flashing-a-Bootloader-to-the-CR-10/ -# ). Once that is done, one should be able to use the standard "make -# flash" command to flash Klipper. +# Note, a number of Melzi boards are shipped with a bootloader that +# requires the following command to flash the board: +# avrdude -p atmega1284p -c arduino -b 57600 -P /dev/ttyUSB0 -U out/klipper.elf.hex +# If the above command does not work and "make flash" does not work +# then one may need to flash a bootloader to the board - see the +# Klipper docs/Bootloaders.md file for more information. # See the example.cfg file for a description of available parameters. |