config: Anet E10 config added

Signed-off-by: Zsolt Olah <beer.olius@gmail.com>
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>

1 files changed, 88 insertions, 0 deletions

diff --git a/config/printer-anet-e10-2018.cfg b/config/printer-anet-e10-2018.cfg
new file mode 100644
index 00000000..7f1b04cc
--- /dev/null
+++ b/config/printer-anet-e10-2018.cfg
@@ -0,0 +1,88 @@
+# This file contains common pin mappings for Anet E10 printer from
+# 2018.  To use this config, the firmware should be compiled for the
+# AVR atmega1284p.
+
+# Note that the "make flash" command does not work with Anet boards -
+# the boards are typically flashed with this command:
+#  avrdude -p atmega1284p -c arduino -b 57600 -P /dev/ttyUSB0 -U out/klipper.elf.hex
+
+# See the example.cfg file for a description of available parameters.
+
+[stepper_x]
+step_pin: PD7
+dir_pin: PC5
+enable_pin: !PD6
+step_distance: .0125
+endstop_pin: ^!PC2
+position_endstop: -3
+position_max: 220
+position_min: -3
+homing_speed: 50
+
+[stepper_y]
+step_pin: PC6
+dir_pin: !PC7
+enable_pin: !PD6
+step_distance: .0125
+endstop_pin: ^!PC3
+position_endstop: -22
+position_min: -22
+position_max: 270
+homing_speed: 50
+
+[stepper_z]
+step_pin: PB3
+dir_pin: !PB2
+enable_pin: !PA5
+step_distance: .0025
+endstop_pin: ^!PC4
+position_endstop: 0.5
+position_max: 300
+homing_speed: 20
+
+[extruder]
+step_pin: PB1
+dir_pin: !PB0
+enable_pin: !PD6
+step_distance: .01
+nozzle_diameter: 0.400
+filament_diameter: 1.750
+heater_pin: PD5
+sensor_type: ATC Semitec 104GT-2
+sensor_pin: PA7
+control: pid
+pid_Kp: 27.0
+pid_Ki: 1.3
+pid_Kd: 136.09
+min_temp: 10
+max_temp: 250
+
+[heater_bed]
+heater_pin: PD4
+sensor_type: ATC Semitec 104GT-2
+sensor_pin: PA6
+control: pid
+pid_Kp: 72.8
+pid_Ki: 1.2
+pid_Kd: 1100
+min_temp: 10
+max_temp: 130
+
+[fan]
+pin: PB4
+
+[mcu]
+serial: /dev/ttyUSB0
+
+[printer]
+kinematics: cartesian
+max_velocity: 300
+max_accel: 1000
+max_z_velocity: 20
+max_z_accel: 100
+
+[display]
+lcd_type: st7920
+cs_pin: PA4
+sclk_pin: PA1
+sid_pin:PA3