diff options
| author | Kevin O'Connor <kevin@koconnor.net> | 2021-06-12 14:13:53 -0400 |
|---|---|---|
| committer | Kevin O'Connor <kevin@koconnor.net> | 2021-06-12 14:16:23 -0400 |
| commit | a0c27571dd0ff841a1464a7df05a8cdd7a2d135d (patch) | |
| tree | d911b8e32d4b8ba38ab448d65c031b7af19f1f21 /config/generic-creality-v4.2.7.cfg | |
| parent | 07004a889d9664eefd65613d79c663d3ca705c20 (diff) | |
| download | kutter-a0c27571dd0ff841a1464a7df05a8cdd7a2d135d.tar.gz kutter-a0c27571dd0ff841a1464a7df05a8cdd7a2d135d.tar.xz kutter-a0c27571dd0ff841a1464a7df05a8cdd7a2d135d.zip | |
docs: Note previous firmware state issue with TMC2209/TMC2209 in TMC_Drivers.md
If a high UART frequency is used to communicate with TMC2208/TMC2209
drivers then it may not be possible for Klipper to communicate with
the drivers until they are reset. Note this in the troubleshooting
document.
Reported by @matthewlloyd.
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
Diffstat (limited to 'config/generic-creality-v4.2.7.cfg')
0 files changed, 0 insertions, 0 deletions