docs: Add BLTouch.md section describing clone config options

Signed-off-by: Kevin O'Connor <kevin@koconnor.net>

1 files changed, 6 insertions, 3 deletions

diff --git a/config/example-extras.cfg b/config/example-extras.cfg
index 12fb3fab..fabb1c6f 100644
--- a/config/example-extras.cfg
+++ b/config/example-extras.cfg
@@ -610,7 +610,8 @@
 #   not run any special G-Code commands on deactivation.
 
 # BLTouch probe. One may define this section (instead of a probe
-# section) to enable a BLTouch probe. A virtual
+# section) to enable a BLTouch probe. See the docs/BLTouch.md guide
+# for further information on configuring a BLTouch. A virtual
 # "probe:z_virtual_endstop" pin is also created (see the "probe"
 # section above for the details).
 #[bltouch]
@@ -632,11 +633,13 @@
 #pin_up_reports_not_triggered: True
 #   Set if the BLTouch consistently reports the probe in a "not
 #   triggered" state after a successful "pin_up" command. This should
-#   be True for all genuine BLTouch devices. The default is True.
+#   be True for all genuine BLTouch devices. Read the directions in
+#   docs/BLTouch.md before setting this to False. The default is True.
 #pin_up_touch_mode_reports_triggered: True
 #   Set if the BLTouch consistently reports a "triggered" state after
 #   the commands "pin_up" followed by "touch_mode". This should be
-#   True for all genuine BLTouch devices. The default is True.
+#   True for all genuine BLTouch devices. Read the directions in
+#   docs/BLTouch.md before setting this to False. The default is True.
 #set_output_mode:
 #   Request a specific sensor pin output mode on the BLTouch V3.0 (and
 #   later). This setting should not be used on other types of probes.