diff options
| author | Kevin O'Connor <kevin@koconnor.net> | 2016-09-15 12:19:30 -0400 |
|---|---|---|
| committer | Kevin O'Connor <kevin@koconnor.net> | 2016-09-15 12:19:30 -0400 |
| commit | 9ff5600421dd38a00f97cc48248096681952081b (patch) | |
| tree | a41f480e24fefdd04eddb867a64576ba3e7e73f5 | |
| parent | 94272ed07211350dd7c76fd20aeeec28eac35c55 (diff) | |
| download | kutter-9ff5600421dd38a00f97cc48248096681952081b.tar.gz kutter-9ff5600421dd38a00f97cc48248096681952081b.tar.xz kutter-9ff5600421dd38a00f97cc48248096681952081b.zip | |
docs: Clarification of some installation and config steps
Signed-off-by: Kevin O'Connor <kevin@koconnor.net>
| -rw-r--r-- | config/example.cfg | 11 | ||||
| -rw-r--r-- | docs/Installation.md | 4 |
2 files changed, 8 insertions, 7 deletions
diff --git a/config/example.cfg b/config/example.cfg index 5614b5fc..090f3653 100644 --- a/config/example.cfg +++ b/config/example.cfg @@ -5,10 +5,9 @@ # FIRST. Incorrectly configured parameters may cause damage. # A note on pin names: pins may be configured with a hardware name -# (such as PA4) or with a board name (such as ar29). In order to use a -# board name, the pin_map variable in the mcu section must specify -# which board definition to use. (See the klippy/pins.py file for the -# available pin and board names.) +# (such as "PA4") or with an Arduino alias name (such as "ar29" or +# "analog3"). In order to use Arduino names, the pin_map variable in +# the mcu section must be present and have a value of "arduino". # Pin names may be preceded by an '!' to indicate that a reverse # polarity should be used (eg, trigger on low instead of high). Input # pins may be preceded by a '^' to indicate that a hardware pull-up @@ -173,10 +172,10 @@ kick_start_time: 0.100 [mcu] serial: /dev/ttyACM0 # The serial port to connect to the MCU -baud: 115200 +baud: 250000 # The baud rate to use pin_map: arduino -# This option may be used to add board specific pin name aliases +# This option may be used to enable Arduino pin name aliases custom: # This option may be used to specify a set of custom # micro-controller commands to be sent at the start of the diff --git a/docs/Installation.md b/docs/Installation.md index f6790742..26266ae8 100644 --- a/docs/Installation.md +++ b/docs/Installation.md @@ -115,7 +115,9 @@ Under "Serial Connection" in "Additional serial ports" add "/tmp/printer". Then click "Save". Enter the Settings tab again and under "Serial Connection" change the -"Serial Port" setting to "/tmp/printer". +"Serial Port" setting to "/tmp/printer". Change the Baudrate field to +250000 (this buad rate field is not related to the firmware baudrate +and may be safely left at 250000). Under the "Features" tab, unselect "Enable SD support". Then click "Save". |